Flywheel MOSFET Motor-Spanning Board
Flywheel MOSFET Motor-Spanning Board
Flywheel MOSFET Motor-Spanning Board
Flywheel MOSFET Motor-Spanning Board

Flywheel MOSFET Motor-Spanning Board

Regular price $11.00 Sale

The MOSFET motor spanning board makes modding a flywheel blaster like the stryfe as easy as possible! No need to replace your switch, and it makes soldering easier!
The board features an optional XT-60U connection point PLUS standard solder terminals. This means you can choose to use an XT-60U or simply solder to the board directly. 
*A note about motor and MOSFET ratings; Our community often overestimates motor current ratings, as many of these are done on paper. Stall current is extremely brief. Because of this, we have rated each of these MOSFET products by the number of motors they can support. We warranty them for this use, rather than giving specific ratings.


• Designed by Out of Darts
• MOSFET rated for any motor pair (2 motors) I sell
• Simple connections, solder to motors directly, then to stock switch and battery
• For use in all elite flywheel blasters 
• Compatible with all standard cages I sell (NOT compatible with canted/tilted cages)
• Compatible with Jupiter (without XT-60U)
• Includes 3D printed spacers for between the motor and board.
• Fits motor (cage) spacing between 37mm and 44mm

• Optional XT-60U solder on connector for easier swapping of cages, wheels, etc.
• Pre-soldered XT-60 battery connectors
Optional switch terminal wiring (allows for plug on board connection)


Customer Reviews

Based on 4 reviews
Joon Taek Oh
Very satisfied, I like very much!

If you are going to use high current motor, you should use this board. You can use space very efficient. I llike this very much.

Captain Ron
Easiest hookup ever.. as long as you have a straight cage and the right hole patterns.

This does not fit canted cages nor does it fit the Eclipse cage when using Kraken motors because the hole pattern you have to use puts the motors at the wrong angle. But when installed in a Worker Titanium cage with Fang Revamps, it makes wiring super simple. You can keep all the stock switches though you do have to rewire them to simple on/off, zero power. Just run your battery wires and you are good to go.

will beck
must for modulus ecs-10

This is a life saver, makes modding the modulus ecs-10 super easy, no modding of the handle which doesn't have much real estate available, or trying to fit a cherry switch with less amp rating. Use the factory rev switch, super simple. Could have used any mosfet setup or board, but this made soldering everything right and easy the first time.

Jim H
Great for clean wiring and high amps

Just finished the first war running this in my stryfe. It makes wiring super easy since I was able to use 22ga wires to the rev switch and ran much heavier guage (14ga) from the battery to the flywheel cage. Couldn't be any easier. I did need to cut out the back when using this with Krakens in my typoon cage.