Daybreak CNC Modulus/Demolisher Flywheel Cage Set
Daybreak CNC Modulus/Demolisher Flywheel Cage Set
Daybreak CNC Modulus/Demolisher Flywheel Cage Set

Daybreak CNC Modulus/Demolisher Flywheel Cage Set

$75.00 Sale

PRODUCT DESCRIPTION:
Daybreak CNC cage for the Modulus/Demolisher with daybreak flywheels, designed by Kuryaka. This cage features the high-concavity Daybreak flywheels and an aluminum body to reduce vibration and act as a heat sink for the motors.

SPECS:
• Adjustable crush of either 40mm or 41mm
• Choose 41mm crush for a mid-crush setup (compatible with hard-tipped darts) 
• Choose 40mm for a high crush setup (NOT compatible with hard-tips)
• Acetal and CNC aluminum
• Machined wheels
• Small root diameter wheels

FPS NOTES:
• These cages while tighter in spacing, also have smaller wheels, yielding comparable crush options to other systems.
• 41mm with entry level motors will yield around 140FPS
• 40mm with entry level motors will yield 160FPS (Further testing needed here)

ADDITIONAL LINKS:
• Wheels without cage
• 3D Printed Daybreak cages

Customer Reviews

Based on 3 reviews
0%
(0)
0%
(0)
33%
(1)
0%
(0)
67%
(2)
J
Justin
Hey Jack

Hey Jack no this was attempted to be installed inside a demolisher 2 in 1 orange shell, the cage itself is the same thickness as the stock cage however when motors are installed they will stick out the back by at least an 1/8 of an inch thus having to over cut the shell leaving motors and wires exposed. The stryfe canted cage from worker tucked the mothers in enough to just shave out the bottom motor area and cut out the top, completely cut out the top cage peg near the access door fits perfect.

J
Jack
Question to Justin

Hi there, I've been thinking about purchasing this cage. Were you perhaps trying to install this cage in a Stryfe?

J
Justin C.
Don’t waste your money

I could not get this cage to fit without cutting the shell to the point where it no longer looked stock, in short i through in a worker canted stryfe cage and it fit like a charm without over cutting.