RedCowl Stryker 2.0 Barrel Collet
RedCowl Stryker 2.0 Barrel Collet
The RedCowl Stryker 2.0 Barrel Collet is an easy addition to your blaster. This 3D part replaces the front end of the Dart Zone Max Stryker 2.0, allowing for the use of other barrels secured with a simple collet. For safety and compliance, these parts will always be printed in OOD Orange filament.
FEATURES:
• Stryker 2.0 Barrel Collet
• Easy, toolless barrel swaps
• Use longer barrels with your super-stock springer
• Easy install through the front of the blaster
• Compatible with hobby barrels 200mm (8in) or longer
• Not compatible with the stock 190mm barrel
• Designed and licensed by RedCowl
INCLUDES:
• 1 Stryker 2.0 front-end collet receiver
• 1 RedCowl Collet
*The collet and front will always be printed in orange.
PERFORMANCE:
Average FPS (Standard Deviation)
• ~220 FPS with 0.527 x 15.5in barrel and OOD 1.9mm spring (coming soon)
SPECS:
• Material: Orange 3D-Printed PLA plastic
LINKS:
• Compatible Barrels
• Stryker 2.0 Springs (Coming Soon)
• Stryker 2.0 Mods + Accessories
Share
Does what it should. Assembly is simple, a little loctite does a great job keeping fasteners in place without having to over tighten them.
Really amazing service and product
The installation is very simple. Remove a few screws, replace the stock barrel mount with the new one, replace the screws and done. Placed a kuryaka barrel on my Stryker and the total process took less than five minutes. Print quality of the piece is great too.
Printed well and does what it promises.
Does what it should. Assembly is simple, a little loctite does a great job keeping fasteners in place without having to over tighten them.
Really amazing service and product
The installation is very simple. Remove a few screws, replace the stock barrel mount with the new one, replace the screws and done. Placed a kuryaka barrel on my Stryker and the total process took less than five minutes. Print quality of the piece is great too.
Printed well and does what it promises.