This feels great! Huge improvement on my GF Trion. Highly recommend the upgrade. One thing to mention: one corner where the clamp split is has a very sharp corner. Used a file to remove that edge/corner. Now it's perfect!
Installed on my Nexus Pro X! The stock grip had too much of a slant. This one I bought is an excellent grip for those that like a little angle but not so much that your wrist is at an uncomfortable angle pumping the grip.
Nice and sleek, but not slippery! Installation is super easy, just the usual hex screws onto the small picatiny rail under the Nexus Pro X.
Would consider buying again for other guns!
I bought this Worker angled long foregrip to replace the stubby vertical one that came with my Worker Seagull, also purchased from OoD at an earlier date. One thing to keep in mind: such Picatinny accessories cannot be finely adjusted back and forth in millimetres. The mounting screws must “settle” in the grooves, which are approximately four or five mm apart. This means that, as out of the box, this ALFG either butts up against the main body at the rear of travel or against a forward bump at the front of travel. I chose to dremel down the front edge, and in a few minutes when I was done, I could hardly tell that anything was visibly changed. But now everything fits and works properly. Yay!
Perfect fit and feel
Excellent grip and as described, just bummed I bought it for my seagull and it doesn't fit. Please remove angle grip from the Seagull mods list.